Bathroom Remodeling in Longwood, FL

A bathroom is the most water-exposed room in the house, so the parts you don't see — waterproofing, slope, drainage, and slab plumbing — matter as much as the tile. We build them to last, not just to look good on day one.

From a straightforward vanity-and-tile update to a full walk-in shower conversion or aging-in-place remodel, we manage plumbing, tile, glass, and finishes for your Longwood home under one contract.

Longwood ranges from the 1970s–80s Wekiva-area neighborhoods — Sweetwater Oaks, Wekiva Cove, The Springs — on larger wooded lots (some on septic) to Sabal Point and the gated Alaqua estates, plus a late-1800s historic district downtown with its own design review. Mature trees and aging roofs, siding and fascia drive much of the exterior work here. For bathrooms, it means checking the drain lines and the slab before the tile is chosen — waterproofing and plumbing age decide more than finishes do.

Longwood’s Wekiva-area neighborhoods — Sweetwater Oaks, Wekiva Cove, The Springs — were built in the 1970s and 80s, and their bathrooms often carry the original tub, tile and drain lines; a remodel there starts with the plumbing before the tile is chosen, and homes on septic need the system considered when a bathroom is added rather than updated. Sabal Point and the gated Alaqua estates bring larger primary baths where the project is a tiled walk-in shower, a freestanding tub and a double vanity.

Plumbing and electrical work is permitted through the City of Longwood Building Division. The late-1800s historic district downtown has its own design review for exterior changes, which rarely touches a bathroom unless a window moves.

Typical time: about 3–5 weeks on site once permits and materials are ready. Selections, the permit review and tile or glass lead times come before the on-site weeks, and the shower glass is measured only after the tile is in.

1. Site visit — we check the drain lines, the slab, the vent and the electrical panel before the tile is chosen; plumbing age decides more than finishes do.
2. Selections and a written, itemised estimate — tile, vanity, fixtures, lighting and glass, with permit fees shown separately and allowances stated.
3. Permit review — filed with City of Longwood Building Division when the scope touches plumbing, wiring or a wall; we answer any review comments.
4. Demolition and rough-in — the old tub or tile out, drain and supply lines moved or replaced, wiring run, then the rough plumbing and electrical inspections.
5. Waterproofing and tile — the sloped, waterproofed base and walls, then tile, floor and the vanity and fixtures.
6. Glass and final — the shower glass measured after tile and installed, the final inspection, the permit closed and a walkthrough with you.